ALL-SPLENDID Wood and Laminate Repair Kit
Floor Repair Pen: L 6.7 x W1.4 x H 0.98 inch (L 17.0 x W 3.5 x H 2.5 cm)
Repair Wax: 6 Different Pieces
Spatula: 1 Pieces
How to use:
1. Insert 3 x AA 1.5V alkaline batteries into the tool, open and slide the ON/OFF switch to the "ON" position.(**Attention: The Batteries are not included**)
2. Hold the tool like a pen.
3. Press the round button and keep pressing for 5 seconds to pre-heat the tip.
4. While still pressing the round button to continue generating heat at the tip, hold the tool with the tip over the floor repair wax to melt the wax.
5.Use the wax with the color similar to the wooden floor. Mix different melted wax to make the correct color if needed.
6.Place the melted wax on the damaged surface of the wooden floor or laminate to fill up the holes or scratches.
7.Allow the melt wax to cool and solidify for 5 ~ 10 seconds.
8.Use the sharp edge of the blade to carefully remove the additional wax and make a flat surface.
Then, the floor will be perfect after to use!!
Important Safety Precautions:
1.Caution-The tool reaches high temperature! Please be careful.
2.Do not touch the hot tip or the hot metal parts when in use!
3.Tips may contain sharp or pointy edges. Use with care.
4.Keep out of reach of children. This is not a toy and not intended for use by children.
(under 12 years old without adult supervision)
5.Misuse may cause burns and injuries.
6.Do not immerse the tool in water!
7.Always use the tool on a heatproof and uncluttered table.
8.After finishing using the tool, let the tool cool naturally, and keep out of reach of children.
9.Ensure the protective cap secures the slide switch at the "OFF" position when storing.
10.For domestic use only. Use only for the intended purpose.